13#There's No Place Like Home II

[Bregi]

It's possible that something isn't working quite well, so let me know here.

And be prepared for the final Season 4 Challenge, but that will take at least 1 month to create

Greez

[criple_ripper]

hey Bregi!!very nice challenge...it's a bit weird to find out how these commands work...i'm still searching how to write them... but anyway...in the form the variables must be posted in your "temp" page abcdeftest.php or theres-no-place-like-home-ii.php?

[Bregi]

I've just deleted abcdeftest, that was just for me
Seen that you solved it. Gratulations!

Bregi

[criple_ripper]

you deleted the file but now the challenge doesn't work...
i think you must change the action in your form...
it was hard to solve it in the requested commands but after looking at it for 40 minutes BAM i got it...great challenge Bregi!!!
many thanks...

[sabretooth]

I fixed it.

Amazing that Bregi can make challenges this complicated yet still make some very basic mistakes xD


sabre

[Bregi]

oh damn yes now I realize it
BUT hehe, yesterday I was working 3 hours on this challenge and after finished it (it was named abcdeftest.php this time) I forgot to change the action name
OK, now it works. Thanks sabre
Greez

[sabretooth]

Bregi, please check that this challenge works correctly. I still think there are problems with it.

Ian

[criple_ripper]

hey sabre...in my opinion(and Bregi's too) that challenge works fine...we tested it and we found 2 possible solutions...

[Bregi]

Ok, I now made a little change in the picture, I removed the
'All incremental (0,0)' information first it was wrong and 2nd I think it could confuse you as a challenger.
Right would be Absolute 0,0. That means (in CNC programming) it all starts from 0, you don't put in the y coordinate and if you are for example at
5 and go 3 up you wont be and 2, you will be on 3.

Hope that made it clearer
Greez

[scorpio_the_first]

great chall, finally managed to control "smokey". But I think the command in the notes for the diagonal moving needs to be adjusted because the x/y coordinates are interchanged.

greez scorp

[Bregi]

great chall, finally managed to control "smokey". But I think the command in the notes for the diagonal moving needs to be adjusted because the x/y coordinates are switched.

greez scorp

Oh, might be, I'll take a look at it tomorrow..

Thanks for pointing it.

Bregi

[thefinder]

Hi, I think it's important to say the start is:
'N00 init S, move x,y,-z;'
It is not explain correctly in the note.